超聲波清洗機 淺談超聲波對不同油品的影響

Mondo 科技 更新 2024-02-26

本文主要介紹超聲波對幾種油脂的影響,如山茶籽油、玫瑰南非醉茄籽油、棕櫚油、花生油和烤鰻魚油。

this article mainly introduces the effects of ultrasound on several oils and fats such as camellia oleifera seed oil, roselle seed oil, palm oil, peanut oil, and roasted eel oil.

1、超聲波輻射對幾種油脂加熱溫度的影響:

1. the effect of ultrasonic radiation on the heating temperature of several oils and fats:

幾種油脂在超聲波作用下溫度不斷公升高,不同型別油脂的公升溫速率不同,其中花生油的溫公升最高,棕櫚油的溫公升最小。 不同的超聲波強度也會以不同的方式加熱幾種油和脂肪。 功率越高,溫度上公升越快。

under the action of ultrasound, the temperature of several oils and fats continuously increases. different types of oils and fats h**e different rates of temperature rise, with peanut oil h**ing the highest temperature rise and palm oil h**ing the lowest temperature rise. different ultrasonic intensities can also cause different heating effects on several types of oils and fats. the higher the power, the faster the temperature rises.

2.超聲波照射後潤滑脂熔點的變化

2. changes in the melting point of oil after ultrasonic irradiation:

在超聲波照射過程中,油品先呈乳白色,然後析出少量絮狀物,然後又會澄清。 這種現象的發生是由於超聲波空化作用加速了油的乳化和團聚,經過一段時間的處理後,由於油的溫度公升高,絮凝物溶解並消失。 超聲波照射後,棕櫚油的熔點降低。

during the ultrasonic irradiation process, the oil initially appears cloudy, and then a small amount of flocculent material precipitates. after a while, it will appear clear again. the occurrence of this phenomenon is due to the accelerated emulsification and coagulation of oil by ultrasonic c**itation. after a period of treatment, the temperature of the oil rises, leading to the dissolution and disappearance of flocculent substances. after ultrasonic irradiation, the melting point of palm oil decreases.

3.超聲波照射時間對油脂酸值的影響。

3. the effect of ultrasound irradiation time on the acid value of oils and fats

棕櫚油和山茶籽油的酸值先下降後公升高,最後呈上公升趨勢。 薔薇籽油和烤鰻魚油的酸值先上公升後降低,而花生油的酸值先下降後上公升。 然而,幾種油脂的酸值在超聲波照射90秒以上後呈上公升趨勢。

the acid value of palm oil and camellia oil initially decreases, then increases, and finally shows an upward trend. the acid value of rose eggplant seed oil and roasted eel oil first increases and then decreases, while peanut oil first decreases and then increases. however, the acid value of several oils and fats showed an upward trend after more than 90 seconds of ultrasound irradiation.

4.超聲波照射時間對油品過氧化值的影響。

4. the effect of ultrasound irradiation time on lipid peroxidation value

棕櫚油和花生油的過氧化值均先下降後公升高,最後呈上公升趨勢。 烤鰻魚油和山茶籽油則相反。 薔薇南非醉茄籽油先下跌後繼續上漲。 可以看出,不同油脂的過氧化值在超聲波照射下變化不同。

the peroxide values of palm oil and peanut oil initially decreased, then increased, and finally showed an upward trend. roasted eel oil and camellia oleifera seed oil are exactly the opposite. rose eggplant seed oil first decreases, and then continues to rise. it can be seen that different oils and fats h**e different changes in their peroxide values under ultrasonic irradiation.

超聲波發生器售出後使用者注意事項:

precautions for users using ultrasonic generators after sale:

電源必須按要求安裝,同時盡可能保持水平。 防止任何導電液體進入超聲波電源,以防損壞。

the power supply must be installed as required and kept as level as possible. prevent any conductive liquid from entering the ultrasonic power supply to prevent damage.

電源箱應放置在乾燥通風的地方,散熱風扇的排熱孔距牆不小於50厘公尺,使散熱系統能夠正常工作。

the power box should be placed in a dry and ventilated place, and the gap between the heat exhaust hole of its cooling fan and the wall should not be less than 50 centimeters to ensure the normal operation of the cooling system.

機器的內部電壓很高,地線必須連線好,以確保操作人員的安全。 在開啟電源開關之前,必須確認電源輸入電纜和超聲波輸出電纜接線正確。

the internal voltage of the machine is very high, and it is necessary to connect the ground wire to ensure the safety of the operator. before turning on the power switch, it is necessary to confirm that the wiring of the power input line and the ultrasonic output line is intact.

如果保險絲在啟動過程中熔斷,更換保險絲時應再次檢查輸出電路,尤其是輸出變送器。

when the fuse is blown during startup, when replacing the fuse, the output circuit, especially the output transducer, should be checked again.

如果上電後不能正常啟動,應立即關閉,開機前應仔細檢查輸出變送器。 嚴禁在工作狀態下隨意移動電源。

if it cannot start normally after startup, it should be immediately shut down and the output transducer should be carefully checked before starting up. it is strictly prohibited to move the power supply arbitrarily while working.

禁止在空載狀態下開機。 電源在出廠時已根據換能器頻率進行了初步調整,一般不需要調整。

prohibit starting up without load. the power supply has been preliminarily adjusted according to the frequency of the transducer at the factory and generally does not require adjustment.

嚴禁將加熱管幹煮。 在沒有清洗液的情況下啟動機器時,嚴禁使用超聲波,在開啟側面超聲波時,要確保清洗槽中的液體不會通過側面換能器的位置。

dry burning of heating tubes is strictly prohibited. it is strictly prohibited to use ultrasound when starting up without cleaning solution. when turning on the side ultrasound, make sure that the liquid in the cleaning tank does not pass through the position of the side transducer.

相關問題答案

    超聲波清洗機 超聲波清洗機在清洗光學方面的優勢

    題目 超聲波清洗機在清洗光學器件方面的優勢。隨著科學技術的發展,光學器件的應用越來越廣泛,如眼鏡 顯微鏡 望遠鏡 照相機等。這些光學元件的清潔度直接影響其效能和壽命。傳統的手動清潔方法費時 費力,而且很容易損壞裝置。超聲波清洗機的問世,給光學器件的清洗帶來了革命性的變化。本文將 超聲波清洗機在清洗光...

    超聲波清洗機 超聲波清洗機在生物製藥行業中的突出作用

    隨著生物製藥行業的快速發展,藥品的質量和生產效率已成為行業關注的焦點。為了滿足日益嚴格的質量標準,許多製藥企業開始採用先進的生產工藝和裝置,以提高生產效率和產品質量。其中,超聲波清洗機作為一種新型的清洗裝置,在生物製藥行業得到了廣泛的應用。本文將詳細介紹超聲波清洗機在生物製藥行業中的突出作用。 提高...

    超聲波清洗機 超聲波清洗機是工業生產的輔助工具

    超聲波清洗機是工業生產的輔助工具隨著現代工業技術的不斷發展,超聲波清洗機在各行各業的應用越來越廣泛。超聲波清洗機作為一種先進的清洗裝置,在保證產品質量和安全的同時,可以有效提高生產效率,降低生產成本。本文將介紹超聲波清洗機在工業生產中的應用及其優勢。一 超聲波清洗機的原理及特點 超聲波清洗機是一種基...

    超聲波清洗機 超聲波清洗機是清洗醫療器械的明智選擇

    超聲波清洗機 醫療器械清洗的首選隨著科學技術的進步,醫療器械的清洗越來越受到重視。傳統的清洗方法,如人工清洗和化學清洗,存在效率低 效果差等缺點。近年來,超聲波清洗機作為一種新型的清洗方式,逐漸成為醫療器械清洗的首選。本文將詳細介紹超聲波清洗機在醫療器械清洗中的工作原理 優勢和應用。 超聲波清洗機的...

    超聲波清洗機 超聲波清洗機是清洗航空航天零件的首選

    超聲波清洗機是清洗航空航天零件的首選,隨著航空航天技術的飛速發展,對清洗航空航天零件的需求也越來越大。由於這些零件的高精度和複雜性,傳統的清洗方法往往無法完全去除其表面的汙垢和雜質,因此需要一種更高效 更精確的清洗方法。超聲波清洗機的出現為解決這一問題提供了有力的支援。 超聲波清洗機的原理和優點 超...