超聲波清洗機的應用範圍很廣，幾乎每個行業都可以使用超聲波清洗機，但對於非專業人士來說，一旦超聲波清洗機的使用出現問題，他們就會不知所措，只能聯絡廠家處理，這必然會對生產進度產生一定的影響。 針對這種情況，總結了以下幾點，對一些簡單故障的排查和處理有幫助。
the application range of ultrasonic cleaning machines is very wide, and almost every industry can use ultrasonic cleaning machines. however, for non professionals, once problems arise during the use of ultrasonic cleaning machines, they will be at a loss and can only contact the manufacturer for treatment, which will inevitably h**e a certain impact on production progress. in response to this situation, the editor has summarized the following points, which are helpful for troubleshooting and handling some **faults.
超聲波清洗機在使用過程中突然停止，一般可能會有以下幾種情況：
during the use of the ultrasonic cleaning machine, if it suddenly stops, the following situations may occur:
1.過流保護：此時，您只需要調整超聲波電流即可恢復正常工作狀態。
1. overcurrent protection: at this time, simply reduce the ultrasonic current to restore normal working conditions.
2、超溫保護：檢查散熱風扇是否正常工作，清理機箱內的灰塵，然後在保證清洗效果的前提下，適當降低超聲波電流，盡可能降低裝置的發熱。
2. over temperature protection: check if the cooling fan is working properly, clean the dust inside the chassis, and then, while ensuring the cleaning effect, appropriately reduce the ultrasonic current to minimize the heat generation of the device.
3、如果超聲波發生器中有元件燒壞，可以先檢查保險絲，如果有損壞，更換保險絲並重新開始試驗，如果仍然不能恢復正常執行，則需要電氣專業人員檢測超聲波發生器中的元件，更換損壞的元件。
3. if any components inside the ultrasonic generator are burnt out, you can first check the fuse tube. if there is any damage, replace the fuse tube and restart the test. if it still cannot resume normal operation, electrical professionals need to inspect the components inside the ultrasonic generator and replace the damaged components.
4、開啟超聲波發生器底盤上蓋，看線路是否有虛連線，重新擰緊所有線路。
4. open the upper cover of the ultrasonic generator case and check for any loose connections in the wiring. all wiring can be re tightened.
5、如果超聲波換能器脫膠或損壞，這種情況只能與廠家溝通，返廠處理。
5. the ultrasonic transducer is detached or damaged, and this situation can only be communicated with the manufacturer and returned to the factory for handling.