工廠的日常生產需要壓縮空氣，也就是我們用的氣幫浦和空壓機，很多廠家都會用到這台機器，一般壓力是3-8bar，空壓機達到8bar後就停止工作，5bar以下啟動。 空壓機的壓力越高，其工作量越大，功耗越大。
in the daily production of the factory, compressed air is needed, which is the air pump and air compressor we use. many manufacturers use this machine, usually with a pressure of 3-8 bar. the air compressor stops working when the pressure reaches 8 bar and starts below 5 bar. for large air compression stations in the factory, power consumption is high. the higher the pressure of the air compressor, the greater its working load and power consumption. below is an introduction to the role played by the air booster pump.
通過相應的國家節能減排號召，根據公司絕大多數壓力只需要6bar左右，將自己的空氣壓縮幫浦的氣壓調整到4bar停止，並利用空氣增壓幫浦進行區域性增壓，這樣生產中的功耗就降低了， 並且工廠內空壓機的維護成本也降低了。
they called for energy conservation and emission reduction in corresponding countries, and according to the majority of the company's pressure, only about 6 bar is needed. they adjusted their air compression pump pressure to 4 bar and stopped using it. by using an air booster pump for local boosting, the power consumption in the production was reduced, and the maintenance cost of the factory's air compressor was also reduced.
實驗表明，使用Finnt壓縮空氣區域性增壓幫浦可節省工廠20%-30%的空氣耗能，並且工廠空壓機站的維護比以前少，成本相對更節約。
through experiments, it has been shown that using a fiente compressed air local booster pump can s**e 20% -30% of the factory's air power consumption. in addition, the maintenance of the factory's air compression station is less than before, and the cost is relatively more s**ed.
空氣增壓幫浦在工廠中的作用不僅用於區域性增壓，還用於工廠生產的產品的氣壓測試和氣密性測試。
the role of air booster pumps in factories is not only limited to local pressurization, but can also be used for air pressure testing, airtightness testing, and other purposes of products produced in factories
空氣增壓幫浦的原理是通過壓縮現有氣壓產生的壓力差而產生的乙個高壓過程，我們又稱空氣增壓幫浦為空氣增壓閥、空氣放大器、氣動增壓幫浦，一般常用的增壓比為：2倍、5倍。
the principle of an air booster pump is to compress the existing air pressure and generate high pressure through the pressure difference generated by the large and small pistons. we also refer to an air booster pump as an air booster valve, air amplifier, or pneumatic booster pump. the commonly used boost ratios are 2 or 5 times.